Here is the current situation. I admin Netwitness on 4 different
networks and all are configured to use NTP. 3 of the networks are fine
and keep time between the SA Head and other appliances w/no issue.
However, on one network, all 8 NW devices have ...
First off, I am a Netwitness fledgling! I recently replaced a couple of
drives that are part of our RAID configuration. Went to replace another
one and mistakenly ran the command to take a drive offline to one of our
Global Hot Spares. The only comma...
trying to figure out how to extract that information via "cat messages".
I've attempted to grep various keywords but haven't been successful
figuring out the exact verbiage to get the info I need. I'll keep trying
but open to suggestions if you alrea...
NTP source is internal. The other 3 networks that I manage have a
secondary NTP source, but this one only has one. Changing it wouldn't do
any good because when I force the Node 0 to sync, it syncs to the
correct time. At one point, I did go in and m...
All devices are not pointing to the NTP source. Only the Node 0 points
to the NTP source and the others are getting time from the Node 0, which
they are doing correctly. So, just the Node 0 is the one with time
accuracy issues and the others just fol...
So, the admin server is the one with the issue. Once I manually sync the
admin server to the NTP server, the others follow suit after a brief
time period (I believe about 10 minutes or so).
