Adding Workbench Service as a Data Source to Broker

Prerequisites

Before adding the Workbench service, you must:

  • Install the Workbench service on the Archiver appliance.
  • Add a collection on the workbench service.

To add the Workbench service as a data source on the Broker:

  1. Go to netwitness_adminicon_25x22.png (Admin) > Services.
  2. Select a Broker service, and select netwitness_actions_icon.png > View > Config.
    The Service Config view is displayed with General tab open.
    121_WbSvcCnfVw_1122.png

  3. In the Aggregate Services section, Click netwitness_add_icon.png.

    The Available Services dialog is displayed.

    netwitness_brwbavailsvc_848x635.png

  4. Select the Workbench service and click OK.

  5. If the Workbench service is using a Trust Model, a Service Authentication dialog for the selected service is displayed.

    netwitness_wb_serv_auth.png

  6. Type the username and password for admin credentials for the service and click OK.

    The Add Service Workbench dialog is displayed.

    netwitness_wbaddcoll.png

  7. Type the username and password for admin credentials for the service and click OK.

    The workbench service is now added as a data source to the Broker and is listed in the NWDATA Sources list.

Note: You must perform this procedure for each collection.