Start a Deployment

The deployment includes ESA services with policy and associated ESA rules. When you initiate deployment, the correlation services start processing sessions from the configured data sources for matching events for the selected ESA rules in the policy.

For more information about ESA services and rules, see Alerting with ESA Correlation Rules

You can start deployments in the following ways:

  • Using the ESA Deployments tab. The ESA Deployments tab provides a consolidated view of all the available deployments within CCM. You can initiate deployments.

  • Using a specific policy. In this method, you cannot view other deployments. You need to go to each policy and initiate a deployment.

To initiate a deployment, with the ESA Deployments tab

  1. Go to Configure.png (CONFIGURE) > Policies > Content.

  1. Under Settings, click Event Stream Analysis > ESA Deployments.

The available deployments are displayed.

  1. Select a deployment and click Deploy.

    ESADEP_deploy_12.3.png

To start a deployment with selected policy

  1. Go to Configure.png (CONFIGURE) > Policies.
  2. In the policies panel, click Content.

    The available policies are displayed.

  3. Click a Policy.

    The selected policy view is displayed and by default Application Rule is selected.

  4. Click Event Stream Analysis Rule > Deployments.

    The available deployments for the selected policy are displayed.

  5. Select the deployment to deploy and click Deploy.

    Note: You can deploy the changes either by performing a Deploy action on selected deployment or by publishing the policy. Publishing a policy with deployment in stopped state, will not deploy the deployment.

 

                                                   Previous Page                                            Next Page