You can stop a deployment to temporarily pause an ESA deployment. This will stop processing the event stream analysis alerts corresponding to the deployed policy.

To delete a deployment completely, see Remove a Deployment

To initiate a deployment again, see Start a Deployment

You can stop deployments in the following ways:

  • Using the ESA Deployments tab. The ESA Deployments tab provides a consolidated view of all the available deployments within CCM. You can stop deployments.

  • Using a specific policy. In this method, you cannot view other deployments. You need to go to each policy and stop a deployment.

To stop a deployment from the ESA Deployments tab

  1. Go to Configure.png (CONFIGURE) > Policies > Content.

  2. Under Settings, click Event Stream Analysis > ESA Deployments.

    The available deployments are displayed.

  3. Select the deployment that must be stopped temporarily and click Stop Deployment.

ESADEP_StopDep_12.3_1321x725.png

To stop a deployment from a selected policy

  1. Go to Configure.png (CONFIGURE) > Policies.
  2. In the policies panel, click Content.

    The available policies are displayed

  3. Click a Policy.

    The selected policy view is displayed and by default Application Rule is selected.

  4. Click Event Stream Analysis Rule > Deployments.

    The available deployments for the selected policy are displayed.

  5. Select the deployment that needs to be stopped temporally and click Stop Deployment.

    Note: Publishing the policy will not deploy the stopped deployments.

    121_stopdeplyment_1222.png