Hello EricSchwartz Good to hear the reboot eventually worked. Please
consider arranging a time to uprade the Series 5 appliance iDRAC, BIOS,
PERC firmware's. iDRAC: -> 2.83.83.83BIOS: 2.4.3 -> 2.11.0PERC:
25.5.3.0005 -> 25.5.7 I notice the PERC firmw...
Hello marcsjohnson Please see the following Dell Community Discussion
which mentions that firmware 2.83.83.83 enforces HTTP or HTTPS Host
Header check by default, which can result in "Access Error: 400 -- Bad
Request". Reference: Upgraded idrac8 firm...
Hello pcalamar I am adding a comment for closure on this request.
Support for Brotli Decompression was added to NetWitness from version
11.6 and above. Reference: RSA announces the release of RSA NetWitness
Platform 11.6 -
https://community.netwitnes...
Hello Inspirisys As will be obvious to you the best solution is to
configure the device that is sending the excessive logs to stop doing
that. It will reduce the logs getting sent to NetWitness and reduce the
unwanted traffic over your network. Alter...
Hello ak-buffercode This issue can appear if you are trying to login
before all the services have fully started after a reboot. If the issue
persists after 15 minutes from startup then review the following
NetWitness Knowledgebase article. Reference:...
